Call us toll free:
86 18588541249
Guangzhou Gaaye Electronics Co., Ltd.
How to install t8 energy saving lamp bracket?
2020-06-10 [ Industry News ]
The method of installing led energy-saving lamps: 1. Disassemble and separate the metal lamp body and the metal hanging board, adjust the balance and tighten the screw rod on the corner of the back metal calendar board and the metal chassis of the lamp body Whether it can be easily drawn out and put into the action test, which is convenient for the subsequent installation steps; and during the installation, the metal hanging plate is adjusted to be parallel to the ceiling and diagonally parallel to achieve the aesthetic effect, and must be firmly installed on the ceiling.Guangzhou Gaaye Electr......
Five connection technologies of terminal blocks
2020-06-09 [ Industry News ]
The terminal block is a common basic accessory product in the automation industry. It mainly completes the effective transmission of intermediate media such as signals and currents. Safe protective devices and light operation are the two core values of the terminal facing the connection market.1. Screw connection2. Welding3. Crimp4. Winding5. Puncture one after anotherGuangzhou Gaaye Electronics Co., Ltdwww.gaaye.com......
Comparison of several terminals？
2020-06-08 [ Industry News ]
1. Wiring with insulating tapeThe method of using insulating tape is the simplest and most common method. Connect the wires by hand wiring first, and then wrap them tightly with insulating tape.Disadvantages: The wiring speed is slow and the loose tape is easy to age, so it is gradually eliminated.2. Ordinary plastic crimping capThis ordinary plastic crimping cap is more advanced than the use of insulating tape for wiring. Just plug the wire into the crimping cap and clamp it with crimping pliers.Disadvantages: It is not easy to clamp when installing, and there will be looseness.Guangzhou Gaay......
Common faults and preventive measures in the use of terminal blocks?
2020-06-06 [ Industry News ]
From the perspective of use, the function of the terminal should be: the conductive part of the contact part must be conductive, and the contact is reliable. The places where the insulation parts should not be conducted must be insulated reliably. There are three common fatal failure forms for terminal blocks:1. Poor contact2. Poor insulation3. Poor fixationGuangzhou Gaaye Electronics Co., Ltdwww.gaaye.com......
Notes on the selection of WAGO terminals
2020-06-06 [ Industry News ]
1. How to chooseSelection mainly considers the following two points1. Is the wire a hard wire or a soft wire?2. What is the cross-sectional area of the wire in square millimeters? (without wire sheath)Second, should I choose to use a few-hole connector? Each connector, no matter how many holes, is internally conductive! Therefore, we need to connect several wires together and use a few holes connector. For example, a 4-hole connector can connect up to 4 wires. If there are only 3 wires to be connected, one hole is enough. Because every connector is electrically connected, the live wire, neut......
