Call us toll free:
86 18588541249
Guangzhou Gaaye Electronics Co., Ltd.
Common faults and preventive measures in the use of terminal blocks?
2020-06-06 [ Industry News ]
From the perspective of use, the function of the terminal should be: the conductive part of the contact part must be conductive, and the contact is reliable. The places where the insulation parts should not be conducted must be insulated reliably. There are three common fatal failure forms for terminal blocks:1. Poor contact2. Poor insulation3. Poor fixationGuangzhou Gaaye Electronics Co., Ltdwww.gaaye.com......
Notes on the selection of WAGO terminals
2020-06-06 [ Industry News ]
1. How to chooseSelection mainly considers the following two points1. Is the wire a hard wire or a soft wire?2. What is the cross-sectional area of the wire in square millimeters? (without wire sheath)Second, should I choose to use a few-hole connector? Each connector, no matter how many holes, is internally conductive! Therefore, we need to connect several wires together and use a few holes connector. For example, a 4-hole connector can connect up to 4 wires. If there are only 3 wires to be connected, one hole is enough. Because every connector is electrically connected, the live wire, neut......
What are the installation steps of the lamp holder？
2020-06-05 [ Industry News ]
1. Put the installed lamp cap on the plastic sleeve, and then insert it into the clip hole on the table lamp clip, put on the washer, and then fix the metal hose and the table lamp clip firmly with screws.2. Strip the insulating layer at the end of the power cord, and then install the power plug.3. Use a multimeter to set the switch to the R×1 range of the resistance, and set it to zero. Connect the red and black watch sticks to the two pins of the power plug. If the resistance is zero, it means that there is a short-circuit fault inside, which should be eliminated immediately.4. Use a multime......
How to connect the screw lamp holder
2020-05-27 [ Industry News ]
how to wire lamp holderFirst of all, make sure that the installed screw base is intactThe screw lamp holder has a simple structure and is easy to install. Before installing the screw base, make sure that the base is intact and there is no leakage, because the structure of the screw base is simple and there are relatively few measures to prevent leakage, so we need to install the screw base before Confirm the quality of the lamp holder.Re-confirm the quality of the screw sockets installed, lamp holder installationWhen we install the screw base, we must first confirm whether the screw ......
2020-05-26 [ Industry News ]
The fill light can only be used as a temporary fill light, not a complete replacement for sunlight.The fill light is suitable for a short period of time (no more than 2 months every six months) when the natural light is not enough, such as wintering / summer / meiyu. If your breeding environment does not have enough natural direct light throughout the year (such as indoors facing east and west), then you are not suitable for raising most Crassulaceae plants, please find another preference.The effect of the common red and blue led plant fill light is similar to scattered light. There is almost ......
